Removing The Pressure Solenoid - Riso RN SERIES Technical Manual

CHAPTER 6. PRESS SECTION

REMOVING THE PRESSURE SOLENOID

2. Removing the Pressure Solenoid
(1) Remove the rear cover.
(2) Remove the mounting screws (M4x8: 3 pcs), and pull the Filter PCB unit [A] forward.
(3) Remove the Second pressure spring [B] and Pressure spring [C].
(4) Unplug the connector [D], remove the mounting screws (M4x8: 4 pcs) on the Solenoid base ass'y [E],
and then remove the Solenoid base ass'y [E].
(5) Unplug the Pressure solenoid connector [G], remove the mounting screws (M3x6: 2 pcs), and then
remove the Pressure solenoid [F].
[Work Precautions]
• The Pressure spring and Second pressure spring are extremely powerful. Take care to avoid injury
when removing or refitting.
[Precautions on Reassembly]
• Align the half-pierce.
A
D
A: Filter PCB unit
B: Second pressure spring
C: Pressure spring
D: Connector
E: Solenoid base ass'y
F: Pressure solenoid
G: Pressure solenoid connector
E
F
6 – 6
RN (Version 1.0)
B
C
G
E