Removing The Thermal Pressure Motor - Riso RN SERIES Technical Manual

CHAPTER 13. MASTER MAKING SECTION

REMOVING THE THERMAL PRESSURE MOTOR

7. Removing the Thermal Pressure Motor
(1) Remove the Master loading unit.
(2) Remove the E-rings and bearings, and then remove the Load roller No. 1 (top) [A].
(3) Remove the De-electricity brush plate [B]. (M3 x 6: 2 pcs)
(4) Remove the Thermal pressure motor [C] as a unit. (M3 x 6: 4 pcs)
B
A: Load roller No. 1 (top)
B: De-electricity brush plate
C: Thermal pressure motor
C
13 – 18
RN (Version 1.0)
A