Omron NJ-series User Manual page 520

Event name Restore Operation Completed
Meaning The restore operation ended normally.
Source PLC Function Module
Error attributes Level
Effects User program
System-defined Variable
variables
None
Cause and Assumed cause
correction
The restore operation ended nor-
mally.
Attached Attached information 1: Operation type
information
0101 hex: SD Memory Card to Controller for switch operation on front of CPU Unit
0201 hex: Computer to Controller
Precautions/ None
Remarks
* This event code was added for unit version 1.03 of the CPU Unit.
NJ-series CPU Unit Software User's Manual (W501)
Source details
Information Recovery
--- Operation
Data type
---
Correction
---
12 Troubleshooting
Event code 901D 0000 hex*
None Detection
timing
--- Log category
Operation does not start after the completion of a restore
operation. To start operation according to the restored
user program and settings, turn OFF the power supply to
the Controller, turn OFF all pins on the DIP switch on the
CPU Unit, and then turn ON the power supply again.
Name
---
Prevention
---
At end of normal
restore operation
System
12
12-49