Initial Settings For The Plc Function Module; Introduction; Controller Setup - Omron NJ-series User Manual

4 Controller Setup

4-2 Initial Settings for the PLC Function
Module
This section describes the initial settings that are required for the PLC Function Module.
4-2-1

Introduction

The initial settings for the PLC Function Module are listed below.

• Controller Setup

• Task Settings
Select Configurations and Setup  Controller Setup and Configurations and Setup  Task Set-
tings on the Sysmac Studio to make these settings
4-2-2 Controller Setup
]
Operation Settings Tab Page
 Basic Settings
The Operation Settings are for functions supported by the CPU Unit, such as the definitions of oper-
ations when the power is turned ON or when the operating mode changes.
Setting
Parameter
group
Operation Startup Mode
Settings
SD Memory Memory Card
Card Setting Diagnosis at
Startup
4-4
Description
Sets the CPU Unit's RUN or PRO-
operating mode at GRAM mode
startup.
Sets whether to execute Do not check.
self-diagnosis (file sys-
Check.
tem check and recovery)
on the inserted SD Mem-
ory Card when the power
is turned ON.
Set value Default
RUN mode
Do not check.
NJ-series CPU Unit Software User's Manual (W501)
Update tim- Changes in
ing RUN mode
When down- Not allowed.
loaded to
CPU Unit
When down- Not allowed.
loaded to
CPU Unit