Applicable Range Of The Backup Functions - Omron NJ-series User Manual

9 Backup Functions
*7 The following data is not processed: Tag data link settings for the built-in EtherNet/IP port, operation authority
verification, and the Data Trace Settings.
Additional Information
The files that are handled for backing up variables and memory from the Sysmac Studio are not
compatible with other backup files. Refer to 9-7 Sysmac Studio Variable and Memory Backup
Functions for details on the Sysmac Studio variable and memory backup functions.
9-1-6

Applicable Range of the Backup Functions

Different types of backup functions handle data for different Units or slaves. The applicable Units and
slaves for each backup function are given in the following table.
Type of backup function
SD Memory Card backups
Automatic transfers from SD
Memory Cards
Sysmac Studio Controller
backups
Importing and exporting Sys-
mac Studio backup file data
Sysmac Studio variable and
memory backup functions
*1 EtherCAT Slave Terminals are included. If EtherCAT Slave Terminals are set for backup, the backup function
applies to both the EtherCAT Coupler Unit and the NX Units.
*2 This does not apply to Safety Control Units. Refer to the NX-series Safety Control Unit User's Manual (Cat. No.
Z930) for information on importing and exporting settings for a Safety Control Unit.
*3 Only importing data is possible. Exporting is not possible.
The Units and slaves that are shown in the following figure are covered by the SD Memory Card backup
functions and Sysmac Studio Controller backup functions.
9-10
EtherCAT
NJ-series
Units and
*1
CPU Unit
slaves
Master Units
OK *2
OK
OK NA
OK *2
OK
OK *3
OK
OK NA
(OK: Applicable, NA: Not applicable)
Units/slaves
CJ-series Units
Ether-
Net/IP
Slaves
slaves
OK NA NA
NA NA NA
OK NA NA
NA NA NA
NA NA NA
NJ-series CPU Unit Software User's Manual (W501)
Computer
and HMIs
NA
NA
NA
NA
NA