Step3: Verifying The Camera Connection Status - IAI GO-2400M-PMCL User Manual

5 Computer
Use a computer that meets the following requirements.
Operating system (OS):
Microsoft Windows Vista 7/8 32-bit/64-bit edition
CPU: Intel Core i3 or higher
Memory:
Windows 7/8 32-bit edition: DDR3, 4 GB or higher
Windows 7/8 64-bit edition: DDR3, 8 GB or higher
Graphics card: PCI-Express 3.0 or higher
6 DC IN / trigger IN connection cable
7 AC adapter (if desired)
Connect an AC adapter to the DC IN / trigger IN connector on the camera. For details on the
connector, see " 4 DC IN / trigger IN connector (4-pin round)" (page 10).
The AC adapter is not required when using PoCL.
™

Step3: Verifying the Camera Connection Status

When the necessary devices are connected and power is supplied to the camera, the power / trigger
LED at the rear of the camera lights amber, and initialization of the camera starts.
When initialization is complete, the power / trigger LED lights green.
Verify whether power is being supplied to the camera and whether the camera is operational by
checking the rear LED.
During normal status
Lit green
™ For details on how to read the LED, see "LED status and camera status" (page 10) in the "Parts Identification"
section.
Note
Initialization of the camera will not complete unless connection with the host is established. If the power /
trigger LED does not switch to green within minutes of supplying power, check the Camera Link cable and
other connections. After initialization is completed once, the power / trigger LED will remain green, even if the
connection with the host is severed.
̶ 15 ̶
GO-2400M-PMCL / GO-2400C-PMCL