IAI GO-2400M-PMCL User Manual page 12

GO-2400M-PMCL / GO-2400C-PMCL
v Clear the [JAI GigE Vision Filter Driver] checkbox, and save.
3
Verify the settings for using Camera Link.
The GO-2400-PMCL supports GenICam and Gen-CP. Check the following settings when
controlling the camera via JAI SDK.
Checking the frame grabber board's settings
Settings must be configured on the frame grabber board to enable Gen-CP support.
For details, refer to the operating instructions for each board.
Checking JAI SDK's settings
u Start JAI Control Tool, and click the (Settings) icon at the top right.
v Check that the [JAI_GenCP_Camera_Link] and [Camera Link Transport Layer] settings are
configured as follows.
̶ 12 ̶