IAI GO-2400M-PMCL User Manual page 58

Access
Function name
type
Offset X R/W Min to Max
Offset Y R/W Min to Max
Binning R/W 1: Off
Horizontal 2: x2
Binning Vertical R/W 1: Off
2: x2
Pixel Format R/W GO-2400M-PMCL:
Mono8
Mono10
Mono12
GO-2400C-PMCL:
BayerRG8
BayerRG10
BayerRG12
PixelColorFilter R/O GO-2400M-PMCL:
None
GO-2400C-PMCL:
BayerRG
Test Pattern R/W Off [Off]
GreyHorizontalRamp [Grey
Horizontal Ramp]
GreyVerticalRamp [Grey Vertical
Ramp]
GreyHorizontalRampMoving
[Grey Horizontal Ramp Moving]
HorizontalColorBar [Horizontal
Color Bar]
VerticalColorBar [Vertical Color
Bar]
MovingColorBar [Moving Color
Bar]
c) Acquisition
Control
Acquisition R/W 0.125 to 127.975
Frame Rate Raw
Trigger Selector R/O FrameStart
[Frame Start]*
Trigger Mode R/W Off
On
Trigger Software W/O —
Trigger Source R/W Low [Low]
High [High]
Software [Software]
PulseGenerator0 [Pulse
Generator 0]
UserOutput0 [User Output 0]
UserOutput1 [User Output 1]
Line4 [Line4 - TTL In]
Line 7[Line7 - CC1]
Nand0 [Nand0 Out]
Nand1 [Nand1 Out]
Trigger Activation R/W RisingEdge [Rising Edge]
FallingEdge [Falling Edge]
LevelHigh [Level High]
LevelLow [Level Low]
Setting range Min. value
0
0
1
1
—
—
—
0.125
—
—
—
—
—
̶ 58 ̶
GO-2400M-PMCL / GO-2400C-PMCL
Max. value Default value
1840 0
1214 0
2 1: Off
2 1: Off
— GO-2400M-PMCL:
Mono8
GO-2400C-PMCL:
BayerRG8
— GO-2400M-PMCL:
None
GO-2400C-PMCL:
BayerRG
—
0: Off
127.975 120.163
— FrameStart
— Off
— —
— Line 7 [Line7- CC1]
— Rising Edge
Description
Set the horizontal
offset.
Set the vertical offset.
Set the number of
pixels in the
horizontal direction
for which to perform
binning.
(Mono only)
Set the number of
pixels in the vertical
direction for which to
perform binning.
GO-400M-PMCL only
Set the pixel format.
Mono12 and
BayerRG12 are
available when Video
Process Bypass
Mode is set to On.
Display the color filter
type that will be
applied to the image.
Select the test image.
ColorBar is only
available on the
GO-2400C-PMCL.
Configure image
capture settings.
Set the frame rate as
a frequency. (unit: Hz)
The maximum value
varies depending on
the TapGeometory
and ROI settings.
Select the trigger
operation.
Display the Trigger
mode.
Execute a software
trigger.
Select the trigger
signal source.
Line4 TTL In is
available on Standard
Model.
Select the polarity of
the trigger signal (i.e.,
location of signal at
which trigger is
applied).