IAI GO-2400M-PMCL User Manual page 14

1 Lens
• C-mount lenses with lens mount protrusions of 9 mm or less can be attached.
• The diagonal of the camera's CMOS image sensor is smaller at 13.4 mm than the 16 mm of 1-inch
models. To prevent vignetting and to obtain the optimal resolution, use a 1-inch lens.
Caution
• The maximum performance of the camera may not be realized depending on the lens.
• Attaching a lens with a mount protrusion longer than 9.1 mm may damage the lens or camera.
Note
The following formula can be used to estimate the focal length.
focal length = WD/(1 + W/w)
WD: Working distance (distance between lens and object)
W: Width of object
w: Width of sensor (11.3 mm on this camera)
2 Direct connection (or MP-43 tripod adapter plate)
When mounting the camera directly to a wall or other device, use screws that match the camera
locking screw holes on the camera. (Large: M3, small: M2, depth: 3 mm)
Use the supplied screws to attach the tripod adapter plate.
Caution
For heavy lenses, be sure to support the lens itself. Do not use configurations in which its weight is supported
by the camera.
3 Camera Link cable
Connect the Camera Link cable to the Mini Camera Link connector.
• Use a cable that supports the Camera Link standard and is compatible with Mini Camera Link
(SDR) connectors.
• Refer to the specifications of the cable for details on its bend radius.
• For details on the cable, see "2 Mini Camera Link connector" (page 9).
Caution
Secure the locking screws on the connector manually, and do not use a
driver. Do not secure the screws too tightly. Doing so may wear down the
screw threads on the camera. (Tightening torque: 0.291±0.049 N·m or
less)
4 Frame grabber board
Refer to the operating instructions of the frame grabber board, and configure settings on the
computer as necessary.
9 mm or less
Lens
̶ 14 ̶
GO-2400M-PMCL / GO-2400C-PMCL
Lens mount protrusion
Secure manually.
Do not secure too tightly.