Supported Lenses; Configuration Procedure - IAI GO-2400M-PMCL User Manual

■ Supported lenses

The GO-2400-PMCL-AUX1 supports the following lenses.
LM16JC5MM
LM35JC5MM
CINEGON 1.9/10
CINEGON 1.8/4.8
SCHNEIDER COMPACTIRIS
MG3518KC
VV1618HF_DN_P
OTHERS
You can use an unsupported lens by setting the lens setting to [OTHERS] and configuring other
necessary information.
The necessary settings are as follows.
Item
P-IRIS Position Limit
P-IRIS Auto Minimum Step No
P-IRIS Auto Maximum Step No

■ Configuration procedure

Configure the following settings when using a P-Iris lens.
1
Start the camera.
Do not connect the P-Iris lens' connector to the camera yet.
2
Set the P-IRIS Lens Control setting to [Off].
3
Select your lens in the P-IRIS Lens Select setting, or select [OTHERS].
• If you are using a supported lens, proceed to step 7.
• If you selected [OTHERS] and are using manual operation, proceed to step 7 after performing
step 4.
• If you selected [OTHERS] and are using auto operation, proceed to step 4.
4
Configure the P-IRIS Position Limit setting according to the specifications of your P-Iris
lens.
5
Set the OPEN-end value for auto iris control by configuring the P-IRIS Auto Minimum Step
No setting.
(Example: OPEN end = 0)
6
Set the CLOSE-end value for auto iris control by configuring the P-IRIS Auto Maximum
Step No setting.
The recommended value is about 80% of the value configured for P-IRIS Position Limit.
(Example: If the P-IRIS Position Limit is 50, set the value to about 40.)
7
Connect the P-Iris lens connector to the camera.
Kowa 16 mm 2/3"
Kowa 35 mm 2/3"
Schneider 16 mm 1"
Schneider 11 mm 2/3"
Schneider P-IRIS unit
CBC 35 mm
Myutron zoom lens
Select this when using a lens not found in the presets.
Set the maximum position value. (manual operation, auto operation)
Set the smallest value configurable for the iris value. (Auto operation only)
Set the largest value configurable for the iris value. (Auto operation only)
̶ 55 ̶
GO-2400M-PMCL / GO-2400C-PMCL
Description