IAI GO-2400M-PMCL User Manual page 74

BlemishWhiteDetect R/W
PositionX
BlemishWhiteDetect R/W
PositionY
VideoSendMode R/W
ShadingCorrection R/W
Mode
ShadingCorrect W/O
RequestShadingDetectResult R/O
ShadingMode R/W
SequenceModeFrame R/W
Count1
SequenceModeFrame R/W
Count2
SequenceModeFrame R/W
Count3
BMPXW Param 1: Blemish
index
Param 2: X
position(Min to
Max)
BMPYW Param 1: Blemish
index
Param 2: Y
position(Min to
Max)
VSM 0: Normal
1: Trigger
Sequence
2: Command
Sequence
SDCM 0: Flat Shading
1: Color Shading*
(*Color model only)
RS
SDRS 0=Complete.
1=Too Bright.
2=Too dark.
3=Timeout Error.
4=Busy.
5=Limit.
6= Trig is not set
as Normal.
SDM 0: OFF
1: User 1
2: User 2
3: User 3
SQF1 Min to Max
SQF2 Min to Max
SQF3 Min to Max
0 255 -1
-1 1935
0 255 -1
-1 1935
0 2 0
0 1 0
0 0 0
0 6 0
0 3 0
1 255 1
1 255 1
1 255 1
̶ 74 ̶
GO-2400M-PMCL / GO-2400C-PMCL
BMPXW=[Param1],[Param2]<CR><LF> Display the x
BMPXW? [Param1]<CR><LF> coordinate
(horizontal pixel
position) of the
correction blemish
selected in
[Blemish Data
Index].
You can also
manually enter the
x coordinate of
the blemish you
want to correct.
BMPYW=[Param1],[Param2]<CR><LF> Display the y
BMPYW? [Param1]<CR><LF> coordinate
(vertical pixel
position) of the
correction blemish
selected in
[Blemish Data
Index].
You can also
manually enter the
y coordinate of
the blemish you
want to correct.
VSM=[Param.]<CR><LF> Set the video
VSM?<CR><LF> send mode.
SDCM=[Param.]<CR><LF> Select the
SDCM?<CR><LF> shading
correction mode.
(Color only / fixed
at Flat Shading for
Mono)
BMRCW=0<CR><LF> Execute shading
correction.
SDRS?<CR><LF> Display the
shading
correction results.
SDM=[Param.]<CR><LF> Set the storage
SDM?<CR><LF> area for the
shading
correction data.
When this is set to
[Off], the shading
correction data is
not saved.
SQF1=[Param.]<CR><LF> Set the frame
SQI1?<CR><LF> count of Sequence
Roi Index1.
(Only enabled
during Trigger
Sequence Mode.)
SQF2=[Param.]<CR><LF> Set the frame
SQI2?<CR><LF> count of Sequence
Roi Index2.
(Only enabled
during Trigger
Sequence Mode.)
SQF3=[Param.]<CR><LF> Set the frame
SQI3?<CR><LF> count of Sequence
Roi Index3.
(Only enabled
during Trigger
Sequence Mode.)