Valid Input/Output Combinations - IAI GO-2400M-PMCL User Manual

Valid Input/Output Combinations

The following signals can be used as sources for each output destination (Trigger Selector, Line
Selector, Pulse Generator Selector).
You can also connect two different sources to NAND paths in the GPIO and reuse the signal generated
there as a source for a different selector.
The combinations of source signals and output destinations are indicated in the following.
switch output)
Source signal
(Cross point
switch input)
LOW
HIGH
Line4 TTL In
Line7 CC1
NAND 0 Out
NAND 1 Out
Pulse Generator 0
User Output 0
User Output 1
Software Trigger
Action 1
Action 2
FVAL
LVAL
Exposure Active
Frame Trigger Wait
Frame Active
Acquisition Trigger Wait
: Indicates default values for each selector. "Factory default values" (page 18) shows the
default values for [Frame Start].
Selector
Trigger Selector
(Cross point
  
  
  
  
  
  
  
  
  
  
  
  
× × ×
× × ×
× × ×
× × ×
× × ×
× × ×
Trigger Source
Output destination
Line Selector
     
     
     
     
× ×
   
     
     
     
     
× × × ×
 
× × × × ×

× × × × ×

×
    
× ×
   
×
    
×
    
×
    
×
    
Line Source
Use
̶ 28 ̶
GO-2400M-PMCL / GO-2400C-PMCL
Pulse
Generator
Selector
  
  
  
  
  
× ×

×
 
  
  
× × ×
× ×

× ×

  
  
  
  
  
  
Pulse
Generator
Clear Source