System Log - Comnet CWGE24MS2 Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL

System log

Introduction
The syslog function records some of system information for debugging purpose. Each log
message recorded with one of these levels, Alert / Critical / Error / Warning / Notice / Information.
The syslog function can be enabled or disabled. The default setting is disabled. The log message
is recorded in the Switch file system. If the syslog server's IP address has been configured, the
Switch will send a copy to the syslog server.
The log message file is limited in 4KB size. If the file is full, the oldest one will be replaced.
CLI Configuration
Node Command
enable show syslog
enable show syslog level LEVEL
enable show syslog server
configure clear syslog
configure syslog-server (disable|enable)
configure syslog-server ipv4-ip IPADDR
configure syslog-server ipv6-ip IPADDR
configure syslog-server facility
Example:
CWGE24MS2#configure terminal
CWGE24MS2(config)#syslog-server ipv4-ip 192.168.200.106
CWGE24MS2(config)#syslog-server enable
TECH SUPPORT: 1.888.678.9427
Description
The command displays the entire log message recorded
in the Switch.
The command displays the log message with the LEVEL
recorded in the Switch.
The command displays the syslog server configurations.
The command clears the syslog message.
The command disables / enables the syslog server
function.
The command configures the syslog server's IP address in
IPv4 format.
The command configures the syslog server's IP address in
IPv6 format.
The command configures the syslog facility level.
CWGE24MS2
INS_CWGE24MS2_REV–
10/05/16 PAGE 276