Tech Support: 1.888.678.9427 - Comnet CWGE24MS2 Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL
CLI Configuration
Node Command
enable show lldp
enable show lldp neighbor
configure lldp (disable|enable)
configure lldp tx-interval
configure lldp tx-hold
interface lldp-agent
(disable|enable|rx-
only|tx-only)
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range lldp-agent
(disable|enable|rx-
only|tx-only)

TECH SUPPORT: 1.888.678.9427

Description
This command displays the LLDP configurations.
This command displays all of the ports' neighbor information.
This command globally enables / disables the LLDP function on the Switch.
This command configures the interval to transmit the LLDP packets.
This command configures the tx-hold time which determines the TTL of
the Switch's message. (TTL=tx-hold * tx-interval)
This command configures the LLDP agent function.
disable – Disable the LLDP on the specific port.
enable – Transmit and Receive the LLDP packet on the specific port.
tx-only – Transmit the LLDP packet on the specific port only.
rx-only – Receive the LLDP packet on the specific port.
This command enters the interface configure node.
This command configures the LLDP agent function.
disable – Disable the LLDP on the specific port.
enable – Transmit and Receive the LLDP packet on the specific port.
tx-only – Transmit the LLDP packet on the specific port only.
rx-only – Receive the LLDP packet on the specific port.
CWGE24MS2
INS_CWGE24MS2_REV–
10/05/16 PAGE 152