Connecting To The Console; Connecting To Computer Or A Lan - Comnet CWGE24MS2 Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL
The RJ-45 Ethernet port fully supports auto-sensing and auto-negotiation.
» Insert one end of a Category 3/4/5/5e (see recommendation above) type twisted-pair cable
into an available RJ-45 port on the Switch and the other end into the port of the network node.
» Check the corresponding port LED on the Switch to ensure that the connection is valid. (Refer
to LED chart)

Connecting to the Console

The console port (DB-9) provides the out-of-band management facility. Use null modem cable to
connect the console port on the Switch and the other end into the COM port of the computer.

Connecting to Computer or a LAN

You can use Ethernet cable to connect computers directly to the switch ports. You can also
connect hubs/switches to the switch ports by Ethernet cables. You can use either the crossover or
straight-through Ethernet cable to connect computers, hubs, or switches.
Notice: Use a twisted-pair Cat5e Ethernet cable to connect the 1000BASE-T port otherwise the
link speed will not be able to reach 1Gbps.
TECH SUPPORT: 1.888.678.9427
CWGE24MS2
INS_CWGE24MS2_REV–
10/05/16 PAGE 15