Comnet CWGE24MS2 Installation And Operation Manual page 19

INSTALLATION AND OPERATION MANUAL
How to enter the CLI
Press [Enter] key to enter the login command prompt when below message is displayed on the
screen.
Please press Enter to activate this console
Input "admin" to enter the CLI mode when below message is displayed on the screen.
CWGE24MS2 login:
You can execute a few limited commands when CLI prompt is displayed as below.
CWGE24MS2>
If you want to execute more powerful commands, you must enter the privileged mode.
Input command "enable"
CWGE24MS2>enable
Input a valid username and password when below prompt are displayed.
user:admin
password:admin
CWGE24MS2#
Node
enable
configure
eth0
interface
acl
vlan
TECH SUPPORT: 1.888.678.9427
CLI command concept
Command
show hostname
reboot
ip address A.B.C.D/M This command configures a static IP and subnet
show
show
show
Description
This command displays the system's network name.
This command reboots the system.
mask for the system.
This command displays the current port
configurations.
This command displays the current access control
profile.
This command displays the current VLAN
configurations.
CWGE24MS2
INS_CWGE24MS2_REV–
10/05/16 PAGE 19