Comnet CWGE24MS2 Installation And Operation Manual page 18

INSTALLATION AND OPERATION MANUAL
Note: Ensure that the terminal or PC you are using to make this connection is configured to
match the above settings. Otherwise the connection will not work.
Then press [ENTER] to open the login screen with the "Default Value" for Username and Password
as "admin".
Management by Telnet
Activate your workstation's command prompt program and access your Switch via the Internet
by typing in the correct IP address (factory default IP address is 192.168.10.1 - connect directly via
console port to configure a unique IP address). Your command prompt program will allow use of
the Telnet protocol.
Connect your computer to one of the Ethernet ports.
Open a Telnet session to the Switch's IP address. If this is your first login, use the default values.
Make sure your computer IP address is in the same subnet, unless you are accessing the Switch
through one or more routers.
TECH SUPPORT: 1.888.678.9427
Setting
IP Address
Subnet Mask
Default Gateway
Management VLAN
Default Username
Default Password
Default Value
192.168.10.1
255.255.255.0
0.0.0.0
1
admin
admin
CWGE24MS2
INS_CWGE24MS2_REV–
10/05/16 PAGE 18