Link Layer Discovery Protocol (Lldp); Tech Support: 1.888.678.9427 - Comnet CWGE24MS2 Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL

Link Layer Discovery Protocol (LLDP)

Introduction
The Link Layer Discovery Protocol (LLDP) specified in this standard allows stations attached
to an IEEE 802® LAN to advertise, to other stations attached to the same IEEE 802 LAN, the
major capabilities provided by the system incorporating that station, the management address
or addresses of the entity or entities that provide management of those capabilities, and
the identification of the station's point of attachment to the IEEE 802 LAN required by those
management entity or entities.
The information distributed via this protocol is stored by its recipients in a standard Management
Information Base (MIB), making it possible for the information to be accessed by a Network
Management System (NMS) using a management protocol such as the Simple Network
Management Protocol (SNMP).
Default Settings
The LLDP on the Switch is disabled.
Tx Interval : 30 seconds.
Tx Hold : 4 times.
Time To Live : 120 seconds.
Port Status Port
---- ------- ----
1 Enable 2
3 Enable 4
5 Enable 6
7 Enable 8
9 Enable 10
11 Enable 12
13 Enable 14
15 Enable 16
17 Enable 18
19 Enable 20
21 Enable 22
23 Enable 24

TECH SUPPORT: 1.888.678.9427

Status
-------
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
Enable
CWGE24MS2
INS_CWGE24MS2_REV–
10/05/16 PAGE 151