Table 3-12: Rj45 Lan Connector Pin Out - California Instruments MX30-1 User Manual

User Manual – Rev AJ
3.7.7 LAN Interface – RJ45
An optional RJ45 Ethernet 10BaseT connector is located on the rear panel for remote control.
standard RJ45 UTP patch cord between the AC Source and a network Hub may be used to
connect the AC source to a LAN. For direct connection to a P
cable is required. Consult your network administrator for directions on connecting the AC sour
to any corporate LAN.
If the –LAN Ethernet interface op
Ethern et port is printed on the serial tag of the power source. The serial tag is located on th
rear pa nel of the unit.
For information on how to set up a network connection or a direct PC
interface, refer to the MX Series Programming Manual P/N 7003-961 distributed in Adobe PDF
format on CD ROM CIC496.
Pin Ethernet TPE
10BaseT/100BastT/1000BaseT
1 Transmit/Receive Data 0 +
2 Transmit/Receive Data 0 -
3 Transmit/Receive Data 1 +
4 Transmit/Receive Data 2 +
5 Transmit/Receive Data 2 -
6 Transmit/Receive Data 1 -
7 Transmit/Receive Data 3 +
8 Transmit/Receive Data 3 -
MX Series
tion is present, the MAC Address (Media Access Control) of the
LAN
EIA/TIA 568A
White with green stripe
Green with white stripe or
solid green
White with orange stripe
Blue with white stripe or
solid blue
White with blue stripe
Orange with white stripe
or solid orange
White with brown stripe or
solid brown
Brown with white stripe or
solid brown.

Table 3-12: RJ45 LAN Connector pin out.

California Instruments
C LAN card, a crossover RJ45
connection using the LAN
EIA/TIA 568B
Crossover
White with orange stripe
Orange with white stripe or
solid orange
White with green stripe
Blue with white stripe or
solid blue
White with blue stripe
Green with white stripe or
solid
White with brown stripe or
solid brown
Brown with white stripe or
solid brown
A
ce
e
61