Table of Contents
Advertisement
User Manual
3.7.9 LAN Interface – RJ45 – J15
An optional RJ45 Ethernet 10BaseT connector is located on the rear panel for remote control. A
standard RJ45 UTP patch cord between the AC Source and a network Hub may be used to connect
th
e AC
source to a L
Consult
your network administrator for directions on connecti
If
the –L N Ethernet interface option is present, the MAC Address (Media Access Control) of the
A
E
thernet port is printed on the serial tag of the power source. The serial tag is located on the rear
panel of the unit.
For information on how to set up a network connection or a direct PC connection using the LAN
interface, refer to the i/iX Compact Series Programming Manual P/N 6005-961 distributed in Adobe
PDF format on CD ROM CIC496.
Pin
Ethernet TPE
10BaseT/100BastT/1000BaseT
1
Transmit/Receive Data 0 +
2
Transmit/Receive Data 0 -
3
Transmit/Receive Data 1 +
4
Transmit/Receive Data 2 +
5
Transmit/Receive Data 2 -
6
Transmit/Receive Data 1 -
7
Transmit/Receive Data 3 +
8
Transmit/Receive Data 3 -
California Instruments
AN
. For direct connection to a PC LAN card, a crossover RJ45 cable is require
Table 3-11: RJ45 LAN Connector pin out.
ng the AC source to any corporate LAN.
LAN
EIA/TIA 568A
White with green stripe
Green with white stripe or
solid green
White with orange stripe
Blue with white stripe or
solid blue
White with blue stripe
Orange with white stripe
or solid orange
White with brown stripe or
solid brown
Brown with white stripe or
solid brown.
2253i / 2253iX
EIA/TIA 568B
Crossover
White with orange stripe
Orange with white stripe or
solid orange
White with green stripe
Blue with white stripe or
solid blue
White with blue stripe
Green with white stripe or
solid
White with brown stripe or
solid brown
Brown with white stripe or
solid brown
d.
44
Advertisement
Table of Contents
