Figure 9-2: Do160 Main Menu; Figure 9-3: Normal State - California Instruments MX30-1 User Manual

User Manual - Rev AJ
Scroll to the RTCA/DO-160D entry using the up and down cursor keys. Press the ENTER key to
select the RTCA/DO 160D main menu. The screen will appear as shown in Figure 9-2.
Note: The user h
9 .3.1.5 AC TESTS
Note: Prior to test selection the standard and the group selection are required. Use the shuttle to
select the standard and the group if applicable.
9 .3.1.5.1 Norm al sta te tes
Sc roll t o the N ORMA
key to select the NORMAL STATE screens. The screen will appear as shown in Figure 9-3.
The DO160 NORMAL 1 and NORMAL 2 screens have the following tests:
1
2
3
4
5
6
7
8
9
The above tests can be selected by scrolling to the highlighted selection using the up and down
key and the ENTER key to start the selected test. For some of these tests, numeric data entry
may be required to define the test n
VOLT FREQ MIN
Standard/Group
Voltage
MX Series
as to turn on the Output relay before starting a test.

Figure 9-2: DO160 Main Menu

t
L STA TE AC entry

Figure 9-3: Normal State

VOLT FREQ MIN
VOLT FREQ MAX
VOLT UNBALANCE
WAVEFORM DISTORTION
VOLT MODULATION
FREQ MODULATION
POWER INTERRUPT
VOLTAGE SURGE
FREQ TRANSIENT (group 1)
FREQ VARIATION (group 2 & 3)
umber or the modulation rate.
RTCA
1 100
using the up and down cursor keys. Press the ENTER
Group1
104
California Instruments
Group2 Group3
104 104
193