Table of Contents
Advertisement
User Manual - Rev AJ
9.2 Opt
ion -HV: A
The -HV option prov
no equivalent 200 VRMS range associated with the -HV option but the standard 0-150 V RMS
and 0-300 V RM
If the -HV option is installed, there will be three volta
PROGAM 1 menu. (
same. Note however that the -HV range is AC coup
capability. Thus, whenever the 400 V range is selected, the output mode is automatically set to
AC MODE and other
Since the –HV option range is AC coupled, the lower frequency limit on the –HV range is 45 Hz
and not the 16 Hz that applies to the standard 150/300V ranges. The upper frequency limit
remains the same.
Arbitrary waveforms
As stated before, the –HV (and –XV) range is AC (transformer) coupled and as such cannot
pass any DC component from the waveform generator. This means that any arbitrary waveform
created by the user that is to be used in the –HV range cannot have any DC offset. The MX
firmware will generate an error message is an attempt is made to select a custom wave
DC offset while in the –HV range.
190
dditi
on
al AC V
oltag
ides an additional AC only output voltage range o
S remain availa
ble even
150
/300/400
). Othe
modes cannot be selected.
e Range
if t
he
-HV
option i
s installe
ge ra
nges that ca
r than the
range v
alues, all o
led a
nd as such o
California Instruments
f 0-400 VRMS. There is
d.
n be
selected from
the
ther op
erations re
main th
ffers
no DC outpu
t
form with
MX Series
e
Hide quick links:
Advertisement
Table of Contents
