User Manual - Rev AJ
9.6.1.6 Revision Selection
The default Re
vision is E. Revisions supported are D and E. The Revision can be changed from
the front panel. Scroll to the REVISION entry
9-33). Use the shuttle to change the selection.
9.6.1.7 AC MODE TESTS
9.6.1.7.1 Steady State Test
Scroll to the STEADY STATE AC entry using the up and down cursor keys. Press the ENTER
key to select the STEADY STA
The MIL704 Steady state 1 and Steady state 2 screens have the following tests:
1
2
3
4
5
6
7
The above tests can be selected by scrolling to the highlighted selection using the up and
cursor keys and the ENTER key to start the selected test.
VOLTAGE
This test will change the output voltage in the following sequence:
•
108V for 1 minute.
•
118V for 1 minute.
•
115V for 1 minut
The ← key (backspace) will terminate the test at any time.
MX Series
Figure 9-33: MIL704 Menu
TE scre ns. The screen will
e
Figure 9-34: Steady State Menu
VOLTAGE
FREQUENCY
VOLT UNBALANCE
PHASE DIFFERENCE
V
OLT MODULATION
FREQ MODULATION
DISTORTION
e.
using the up and down cursor keys (see Figure
appear as shown in Figure 9-34.
California Instruments
down
227