Figure 4-27: Measurement Cal Factors Menu (Series I Only); Figure 4-28: Measurement Cal Factors Menu (Series Ii Only) - California Instruments MX30-1 User Manual

User Manual – Rev AJ
4.2.13 MEASUREMENT CAL FACTORS Menu

Figure 4-27: MEASUREMENT CAL FACTORS Menu (Series I only)

Figure 4-28
The MEASUREMENT CAL FACTORS menu
parameters. The parameters apply to the selected mode of operation (AC or DC mode). For
three phase configurations, the PHASE keys toggle between the three calibration screens for
each phase. These parameters are password protected and can only be changed after the
calibration password has been entered. Refer to the calibration section in this manual for details
on performing a calibration.
Note that Series II MX models only have two measurement calibration factors. Series I models
require additional cal factors as shown. The following calibration factors are available from this
menu:
Entry
VOLT FS
VOLT 0
VOLT FS HT
VOLT 0 HT
CURR FS
CURR 0
CURR FS HT
CURR 0 HT
MX Series
: MEASUREMENT CAL FACTORS Menu (Series II only)
provides access to the measurement calibration
Description
Full scale voltage measurement calibration factor.
Zero offset voltage measurement calibration f
only)
Temperature compensated full-scale voltage measur
calibration factor. (Series I only)
Te mperature compensated zero offset voltage measurement
calibration factor. (Series I only)
Full scale current measurement calibration factor.
Zero offset current measurement calibration factor. (Series
only)
Temperature compensated full-scale current measurement
calibration factor. (Series I only)
Temperature compensated zero offset current measureme
calibration factor. (Series I only)
California Instruments
actor. (Series I
ement
I
nt
117