Table 9-1: Normal Voltage And Frequency Minimum; Table 9-2: Normal Voltage And Frequency Maximum; Table 9-3: Normal Voltage Unbalance - California Instruments MX30-1 User Manual

User Manual - Rev AJ
Frequency
Standard/Group
Voltage
Frequency
This test will set the voltage and frequency to levels defined by Table 9-1. The test will last for 30
minutes. The test will be repeated for the Group 2 a
and the frequency from Table 9-1. T
VOLT FREQ MAX
This test will set the voltage and frequency to levels defined by Table 9-2. The test will last for 30
minutes. The test will be repeated for the EURO standard using the Voltage setting from
Table 9- 1 a nd the freq
at any time. Group execute trigger will terminat
remain at 115 volts. The
VOLT U NBALANCE
Standard/Group
Voltage offset
Frequency
This test will chang t
Table 9-3 for the offset value and the Frequency. The test will last 30 minutes. The test will be
repeated for a second Frequency if applicable. The test can be terminated at any time.
The ← key will terminate the test at any time.
WAVEFORM DISTORTION
This test will generate a 5% THD voltage distortion on the output voltage waveform. The
distortion is generated by using a clipped sine wave. The test will last for 30 minutes. The ←
key (backspace) will terminate the test at any time.
VOLTAGE MO ULA D TION
This test requires a numeric value entry equal to the modulation rate in Hz. This entry value
must be between 1 Hz and 200 Hz. The amplitude modulation is calculated based on the
modulation rate as defined in Figure 9-4. This test will last for 2 minutes.
194
3 101.5
380
Table 9-1: N orma l Vol tage
RTCA
1 122
3 120.5
420

Table 9-2: Normal Voltage and Frequency Maximum

he ← key (backspace) will terminate the test at any time.
uenc y from Tab le 9-2 . The CLR Ke
← key (backspace) will terminate the test at an
RTCA
6
400

Table 9-3: Normal Voltage Unbalance

e he output voltage for each phase from 115 volts to 115V + offset. Refer to
105.5
390
and Freq uency Minimum
Group1
122
120.5
410
nd 3 using the Voltage setting from Table 9-2
y in lo cal op
e the test remotely. The unselected phases will
Group1 Gro up2
6 6
400 360/650
California Instruments
105.5 105.5
360 360
Group2 Group3
122 122
120.5 120.5
650 800
eratio n wil l terminate the test
y time.
Group3
9
360/800
MX Series