Figure 9-26: Iec 1000-4-13 Interharmonics; Figure 9-27: Iec 61000-4-13 Meister Curve - California Instruments MX30-1 User Manual

User Manual - Rev AJ
4. PAUSE
IINTERHARMONICS GROUP
If the Harmonics group is selected, the screen will appear as shown in Figure 9-26. The screen
has the following parameters that are unique to the group:
1 . LEVEL
2. FRANGE
3. STEP
4. IHFREQ
5. PAUSE
MEISTER CURVE GROUP
If th M ster cu e grou e ei
scre n h s the f llowing e a
1. LEVEL
fundamental. The level is fixed for the entire frequency range defined by FRANGE. To
change levels, the test state must be off and user class must be selected.
2. FRANGE
required to change the level. An individual range step can be run by selecting the
desired range, followed by RUN RANGE from the RUN field.
3. STEP
fixed for the entire range of the sweep. The STEP size can be changed when the test
state is off.
218
Sets the pause time in seconds between harmonics tests. There is only one
value fo r the entire test. The PAUSE value can be changed when the test is not
running.
Figure 9 -26: IEC 1000-4-13 INTERHARM
Sets the percentage level of the inter harmonics relative to the fundamental.
The level is fixed for the entir
change levels, t he test state must be off and user class must be selected.
The range is selected by rotating the shuttle.
change the level. An individual range step can be run by selecting the desired
range, followed by RUN RANGE from the RUN field.
The step size defines the inter harmonics sweep points. This step size is fixed
for the entire range of the sweep. The STEP size can be changed when the
test state is off.
This field shows the current inter harmonic frequency when the test is running.
An inter harmonic frequency can be selected with the shuttle. To run an inter
harmonic frequency without sweeping through the entire range, RUN POINT
must be selected.
Sets the time in seconds for which the test will pause between inter harmonic
frequencies. There is only one value for the entire test. The PAUSE c
when the test is not running.
rv p is selected, the screen will appear as shown in Figure 9-27. The
o parameters that are unique to the group:

Figure 9-27: IEC 61000-4-13 Meister Curve

Sets the percentage level of the inter harmonics relative to the
The range is selected by rotating the shuttle. The range selection is
The step size defines the inter harmonics sweep points. This step size is
ONICS
e frequency range defined by FRANGE. To
T he range selection is required to
California Instruments
an be set
MX Series