Figure 4-23: Initial Setup Menus - California Instruments MX30-1 User Manual

User Manual – Rev AJ
4.2.11.3 INITIAL SETUP menu
Any time the power source is powered up, the output will reflect the values stored as the INITIA
setup values. This allows the unit to be powered up in a known state at all times. The INITIAL
values can be set in the INITIAL SETUP menus.
The initial setup can be used to power up the power source with the output on and a high
voltage present at the output. For
potential danger to the operator. It is recommended that the initial voltage be set low and/or the
output relay be programmed to O
The following fields are provided in the INITIAL SETUP menus:
Entry
VOLTAGE
CURR L IMIT
FREQ
PHASE
VOLT RAN GE
VOLT MODE
OL MODE
OUTPUT RELAY
VOLT SENSE
MX Series

Figure 4-23: INITIAL SETUP Menus

normal situations, this is not re
FF for most situations.
Description
INITIAL SETUP 1
Sets the power-on AC voltage for AC and AC+DC m
DC voltage for DC mode.
Sets the power-on current limit value.
Sets the power-on frequency value.
Sets the power-on frequency for phase A with respect to an
external sync signal. If the internal oscillator is used (default)
this setting has no effect.
INITIAL SETUP 2
Sets the power-on voltage range value.
Sets the power-on voltage mode. Available settings are AC
mode, DC mode or AC+DC mode.
Sets the power-on overload mode. Available settings are
Constant Current (CC) or Constant Voltage (CV) mode.
Sets the power-on state of the output relay. Available settings
are ON or OFF.
INITIAL SETUP 3
Sets the power-on state of the voltage sense mode. Ava
settings are Internal (INT) or External (EXT).
California Instruments
commended due to the
odes or the
L
ilable
111