Option -Whm: Watt Hour Measurement; Figure 9-43: Application Screen; Figure 9-44: Watt-Hour Meter Screen; Figure 9-45: Wh-Meter Screen With Function Active - California Instruments MX30-1 User Manual

User Manual - Rev AJ
9.10 Option –WHM: Watt Hour Measurement
9.10.1 General
This section describes the WHM option available for the MX Series Power Source.
9.10.2 Specification
All specifications are the same as the standard MX Power Source specifications in addition to
the following specifications:
Watt-hour
0-6.000KW
> 6.00 0KW
9.10.3 Local Operati on
•
From the Menu screen 2, select the A
as shown in Figure 9-43. Use the up
field. Press the Enter Key.
•
The W AT T-HOURS METER screen s
1. START: T his field
field is highlighted will activate the watt-hour func
Figure .
2. ETIME: T his field will accumulate the
3. WATT HR: This field will accumulate the watt-hour in KWH.
4. POWER: This field will report the instantaneous power in KW.
5. PK CURR: This field will report the peak current and will hold the maximum reading.
MX Series
0.2%FS +0.1%R
0.5%FS +0.1%R
Times three of the above specifi
PPLICATIONS SETUP
and down key to position

Figure 9-43: Application Screen

hown in Figure 9-44 ha
Figure 9-44 : Watt-Ho
will activate the watt our measurements. Movin -h
time in hours, minutes and sec
Figure 9-45: WH-M
<100 H
100-819
s th
ur Meter Screen
tion and the field will change to STOP as shown in
eter Screen with Function A tive
California Instruments
z
Hz
cation
2 s creen. The screen will appear
th e cursor to the WH METER
e following fields:
g the shuttle clockwise when
onds.
c
the
237