Table 9-10: Abnormal Voltage Minimum; Table 9-11: Abnormal Voltage Maximum; Table 9-12: Abnormal Frequency Transient - California Instruments MX30-1 User Manual

Mx series ac and dc power source series i / series ii

Table of Contents

User Manual - Rev AJ

VOLT DROP

FREQ TRANSIENTS

The above test can be selected by scrolling to the highlighted selection using the up and down

key and the ENTER key to start the selected test.

VOLT M

Standard/Group

Voltage

Frequency

Standard/Group

Voltage

Frequency

This test will set the voltage and frequency to levels defined by Figure 9-10 for 5 minutes. The

test will be repeated for Group1 only as indicated in Table 9-10 for voltage and Table 9-11 for

frequency. All Groups will repeat the test using Table 9-10 for the voltage setting and Table 9-

10 or Table 9-11for the frequency setting. The ← key (backspace) will terminate the test at any

time.

VOLT M

This test will set the voltage and frequency to levels defined by Table 9-11 for 5 minutes. The test

will

repe

ated for Gro

Tab

le 9-1

1 for the voltage setting and Table

ill te

rminat

e th

VOLT UNDER

This te

st wil

l dro

OLT S

URGE

This test requires 180 volt output voltage. If t

the high voltage range will be selected before the test starts. At the end of the test the AC

ource

will b

e s

The output voltage will surge to 180 volts for 100 ms. followed by drop to 148 volts for 1 sec

before it returns to 115 volts. The ← key (backspace) will terminate the test at any time.

FREQUENCY TRANSIENTS (Group 1 only)

MX Series

RTCA

98.5

400