Table of Contents
Advertisement
User Manual
10.5 Front Panel Operation MIL704
To perform a test from the keyboard, from the MENU screen, select the APPLICATIONS screen. The
APPLICATIONS screen will appear as shown in Figure 10-1.
Scroll to the MIL-STD-704 entry using the up and down cursor keys. Press the ENTER key to select
the MIL704 main menu.
Note: The user has to turn on the Output relay before starting a test and set the steady state setup for
the test. NOM FREQ must be set to match the desired steady state frequency. All MIL704 revisions
will accept 400Hz as a nominal frequency. Revision F only will accept 60Hz and VFREQ.
10.5.1 Revision Selection
The default Revision is E. Revisions supported is D, E and F. The Revision can be changed from the
front panel. Scroll to the REVISION entry using the up and down cursor keys (Figure 10-2). Use the
shu
ttle to change the selection.
10.5.2 Nom
inal Frequency Selection
Three selections are available for the nominal frequency to be used:
400Hz, this selec
VFREQ, this selection is active for revision F only. Program frequency must be set between
360Hz and 800Hz to run the tests.
60Hz, this selection is active for revision F only. Program frequency must be set to 60Hz to
run the tests.
Note that the programmed frequency of the AC source must be the same s th
frequenc
y selected in th
attemptin
g to ru a test
screen. Select
ing
frequency programmed.
California Instruments
Figure 10-1: Applications Menu
Figure 10-2: MIL704 Menu
tion is active in all revisions. Program frequency must be set to 400Hz.
e 704 scree
n. If not, a S
n
. T
he programmed
the nom
inal t
est fr
equen
etting Conflict
error w
fre
quency can
only b
e c an
cy
in t
he 7
04 A
pplic
ation scre
2253i / 2253iX
a
e selected nominal test
ill be generated when
h
ged from the normal setup
en does not change the output
133
Advertisement
Table of Contents
