Table of Contents
Advertisement
User Manual
2.6 Available Options – i Series
Interface Options
Misc. Options
-MODE
California Instruments
-GPIB
GPIB Remote control interface. This option is not field installable and
must be specified at the time of original unit order.
-ABL
Atlas Based Language Extension. The ABLE command language
provides bus compatibility with 9012 PIP controllers.
-EXT
External Signal Input. This option allows a 0-5Vrms AC signal to be used
as the oscillator signal. In this mode, the AC power source acts as an AC
amplifier. No programmable current limit is available and the output
frequency of 1000 Hz should not be exceeded. Mutually exclusive with –
RPF and –RPV options.
Mode option allows all three amplifier outputs to be combined on phase A
output terminal. No external switching or reconnection to the load is
required.
-RMS
Set of 2 Rack mount slides. (Left and Right) Recommended to mount
chassis in 19-inch instrument cabinet.
-RPV
Remote programming voltage. DC voltage input 0 to 10 VDC for 0 to full-
scale output voltage programming.
-RPF
Remote programming frequency. DC voltage input 0 to 10 VDC or 0 to 5
VDC for 0 to 800 Hz output frequency programming. Input impedance is
20 Kohm (RPF10) or 10 Kohm (RPF5).
This option is mutually exclusive with the –LKS option.
-WHM
Watt-hour measurement option.
2253i / 2253iX
26
Advertisement
Table of Contents
