Final Installation Setup - 2gig Technologies Go Control Install Manual

FINAL INSTALLATION SETUP

EXITING PROGRAMMING
(SYSTEM CONFIGURATION)
After programming the Control Panel, all the
changes need to be saved in memory. After saving,
the programmed settings will remain in memory,
even after a total power loss.
After setting all the required programming
1
values for the sensors and the Control Panel,
press End.
Review the Summary of System Configuration
2
Screen. Use the ↓ and ↑ arrows to scroll
through the listing. Verify that each option is
set correctly.
3 To save the programming changes, be sure the
Save Changes option is checked. To exit
without saving programming changes un‐
check the Save Changes option (for
verification, an additional confirmation screen
appears). Press Exit.
The Control Panel takes a few seconds to
4
restart and display the Home Screen.
Customizing the Installation
After programming the Control Panel, go to the
User Toolbox and customize the system to suit the
installation. To access the User Toolbox, do the
following:
1 From the Home Screen, press Security.
2 From the Security Screen, press, Menu.
3 From the Menu Screen, Press Toolbox.
4 Enter the Master User Code (default = 1111).
Press User Management.
5
To add, change, or delete a User Code, press a
6
User button. The system asks to confirm the
56
©2013 2GIG Technologies Inc. All Rights Reserved.
code entered. Be sure to set a Duress Code as
User #8.
User codes 0000, 0001, and the
NOTE:
Installer Code are not permitted.
Setup each User Code with the User Access
7
Option Screen. Each User Code can be set to
be currently valid or not, or to have
conditional validity. Refer to the User Guide for
details on setting User Code Access Schedules.
When done, press Back.
Press Brightness/Volume. Set the level for the
8
display brightness. Set the chime & voice
volume. When done, press Ok.
To view the 2nd Toolbox Screen, press →. To
9
set the display lighting timeout, press Back
Light Timeout. Choose the length of time that
the display will remain lit after it is idle. When
done, press Ok.