Final Installation Setup; Exiting Programming; Customizing The Installation - 2gig Technologies Go!Control 2GIG-CNTRL2 Installation & Programming Instructions

Exiting Programming

After programming the Control Panel, all the changes need to
be saved in memory. After saving, the programmed settings will
remain in memory, even after a total power loss.
1. After setting all the required programming values for
the sensors and the Control Panel, press END.
2. Review the Control Panel Summary screen. Use the ↓ and ↑ arrows
to scroll through the listing. Verify that each option is set correctly.
3. To save the programming changes, be sure the SAVE CHANGES
option is checked. To exit without saving programming changes
un-check the SAVE CHANGES option (for verifi cation, an additional
confi rmation screen will display). Press EXIT. The Control Panel
will take a few seconds to restart and display the Home Screen.
Figure 57. Programming Summary Screen

Customizing the Installation

After programming the Control Panel, go to the User Toolbox and
customize the system to suit the installation.
1. After the Control Panel restarts, press SECURITY, MENU, TOOLBOX to
access the User Toolbox. Enter the Master User Code (default = 1111).
Figure 58. User Toolbox Screen 1 of 3
2. Press USER MANAGEMENT.
3. Setup the User Codes. Press a User button to add, change,
or delete a User Code. The system will ask to confi rm the
code entered. Be sure to set a Duress Code as User #8.
✓ NOTE: User codes 0000, 0001, and the code used
for the Installer Code are not permitted.
4. Setup each User Code with the User Access Option Screen. Each
User Code can be set to be currently valid or not, or to have conditional
validity depending on a time and date schedule. Refer to the User's
Guide for details on setting User Code Access Schedules.
5. Press BACK when fi nished.
Figure 59. User Management Screen

Final Installation Setup

6. Press BRIGHTNESS / VOLUME. Set the level for the display
brightness. Set the chime & voice volume. Press OK when fi nished.
Figure 60. Brightness / Volume Screen
7. Press → to view the second User Toolbox screen.
Figure 61. User Toolbox Screen 2 of 3
8. Press BACKLIGHT TIMEOUT and set the display lighting
timeout. Choose the length of time that the display will
remain lit after it is idle. Press OK when fi nished.
Figure 62. Backlight Timeout Screen
9. Press SET DATE and SET TIME to set the calendar and clock. On
the Set Date screen, use the ↓ and ↑ arrows to set the month, day,
and year. On the Set Time screen, use the ↓ and ↑ arrows to set the
hours, minutes, and AM/PM. Press OK when fi nished. A confi rmation
screen will show. Verify the time and date, then Press OK.
✓ NOTE: If the GSM radio module is installed and registered, the
date and time will be set automatically.
Figure 63. Set Date Screen
10. Press BACK to return to the Security Screen or press
the button to return to the Home Screen.
The installation and installer programming of the Control Panel is
now complete. Continue to the next section to test the system.
39