Table of Contents
Advertisement
RF KEY FOB PROGRAMMING
The Control Panel can be programmed with up to 8
RF Key Fobs.
Programming the RF Key Fobs into the Control
Panel involves selecting the sensor number for a
particular device, setting or learning the RF Key
Fob's serial number, and selecting the other options
for the sensor.
RF Key Fobs 1 ‐ 8 report to the
IMPORTANT:
Control Panel as sensors 51 ‐ 58 (opening/
closing, emergency, and low battery reports).
RF Key Fob #1 Reports as sensor #51
RF Key Fob #2 Reports as sensor #52
RF Key Fob #3 Reports as sensor #53
RF Key Fob #4 Reports as sensor #54
RF Key Fob #5 Reports as sensor #55
RF Key Fob #6 Reports as sensor #56
RF Key Fob #7 Reports as sensor #57
RF Key Fob #8 Reports as sensor #58
See the diagram for the steps required to program
RF Key Fobs into the Control Panel. The options that
can be set for each RF Key Fob are:
•
Key Fob Number — Key Fob number 1‐8
•
Key Fob Used — Key Fob used or not
•
Key Fob Equipment Code — Key Fob model
•
Key Fob Other Equipment Code — Enter
special equipment code (only shown for Key
Fobs set as "other")
•
Key Fob Serial # — Serial number labeled on
Key Fob; "learn‐in" by sending signal
•
Key Fob Equipment Age — New unit or existing
Key Fob
•
Key Fob Emergency Key — Choose function of
double‐press on top buttons
•
Key Fob Can Disarm — Choose whether a Key
Fob is allowed to disarm the system
•
Key Fob Voice Descriptor — Name assigned to
the Key Fob
•
Key Fob Arm No Delay — Choose if Key Fob will
arm instantly without an Exit Delay
•
Key Fob Key 4 Output — Select action for Key
Fob auxiliary button
Scroll between op ons using the ← and →
1
arrows. Move to the previous or next prompt
by pressing the ↑ and ↓ arrows.
2
To program another sensor click next.
3
To exit programming, click skip then end and
exit. Upon exit, the panel takes a several
seconds to reboot.
TIP:
Pressing Skip goes to question Q‐4. See "RF
Keypad Programming Steps" on page 40.
©2013 2GIG Technologies Inc. All Rights Reserved.
37
Advertisement
Table of Contents
Need help?
Do you have a question about the Go Control and is the answer not in the manual?
Questions and answers