Table of Contents
Advertisement
Go!Control Wireless Security System | Install Guide
Scroll between op ons using the ← and →
1
arrows. Move to the previous or next prompt
by pressing the ↑ and ↓ arrows.
To program another sensor click next.
2
3
To exit programming, click skip then end and
exit. Upon exit, the panel takes a several
seconds to reboot.
34
©2013 2GIG Technologies Inc. All Rights Reserved.
Wired Sensor Programming Screen
After setting all the options for a sensor, the wired
sensor summary screen is displayed. The screen
can also be displayed for programmed sensors
during wired sensor program editing by pressing
the Sum button.
•
While programming each wired sensor
remember that the ← and → arrow bu ons
step through each of the wired sensor
numbers.
•
To return to programming, click the edit
current or edit next buttons.
•
Pressing skip goes to question number Q‐3 (RF
Key Fob Programming). See "RF Key Fob
Programming" on page 37.
For the detailed steps of programming
NOTE:
a wired sensor, see the following page.
Advertisement
Table of Contents
Need help?
Do you have a question about the Go Control and is the answer not in the manual?
Questions and answers