Wireless Installation Tips - 2gig Technologies Go Control Install Manual

Go!Control Wireless Security System | Install Guide
WIRELESS INSTALLATION TIPS
When installing any wireless system, consider
certain limitations. Low power wireless transmitter
signals do NOT broadcast equally through all types
of construction materials. However, the Control
Panel contains a very sensitive receiver that should
allow for placement of transmitters in almost all
locations. Review the following illustration before
beginning the installation for the best possible
placement of wireless sensors.
CONTROL PANEL MOUNTING
PLATE
Mount the Control Panel on the wall in an easy
location (or optional desk mount) for the
subscriber to operate the system.
Some special tools may be required to mount the
Control Panel onto the wall:
• Screwdriver
• Wire stripper
• Staple gun
• Drywall saw (or equivalent)
• Ladder
10 ©2013 2GIG Technologies Inc. All Rights Reserved.
Remove the locking screw from the top of the
1
Control Panel case and remove the mounting
plate.
Use the mounting plate as a template to mark
2
the wall for the wiring cutout slot. Use a
drywall saw to cut the slot. If using the
optional Cell Radio Module with an external
antenna, remove the plastic knockout labeled
"EXTERNAL ANTENNA" on the mounting plate.
Mark and cut a slot in the drywall for the
external antenna.
Attach the mounting plate to the wall using 3
3
screws.
A Mounting plate
B Remove case screw and mounting plate
C Use mounting plate as a template to mark wire cutout
hole in dry wall.
D If using external antenna, remove knockout plate.
E Mount plate with 3 screws.
WIRELESS SENSORS
Following the instructions included with each
wireless sensor, install each sensor at its desired
location.