Introduction - 2gig Technologies Go Control Install Manual

Hide thumbs Also See for Go Control:

Table of Contents

INTRODUCTION

This 2GIG security system is a fully supervised wireless security system that you can program remotely using

a smart phone or tablet. The 2GIG Control Panel and security system incorporates the most advanced and

sophisticated features available. The system (including the Control Panel and peripheral devices) can be

expanded and customized to fit each installation's specific needs.

Designed to meet or exceed the requirements for ETL Listed residential security equipment, the system also

conforms to the Security Industry Association's Control Panel Standard ANSI/SIA CP‐01‐2013.

Failure to install the Control Panel and accessories in accordance with ETL requirements listed in

NOTE:

this manual voids the ETL listing mark.

Many insurance companies offer discounts on homeowners' and renters' policies when a security system is

installed. Discount credits vary with different companies and generally increase in savings with an increase

in the level of protection. Inform the user to ask their insurance agent about savings available.

This security system is ETL Listed. For use as a smoke alarm system, there must be at least one smoke

detector programmed into the Control Panel. Many insurance companies require meeting these

requirements to qualify for a discount. Use only approved model smoke detectors with this Control Panel.

Fire warning systems installed in the United States must be installed in accordance with the national Fire

Alarm Code, ANSI/NFPA 72, and the National Electrical Code, ANSI/NFPA 70.

NOTE:

Some cities and municipalities may require an alarm system permit. Check with the local

authorities before installing this system.

IMPORTANT: If this installation is a commercial installation, please inform the customer (or end user) that

commercial Control Panels are for use only as burglar alarm systems (and not for fire protection) under UL

1610.

For additional commercial regulatory information, see "Recommended Commercial Installations" on page

15, "Commercial Control Panel Diagram" on page 16 and "Commercial Regulatory Listings" on page 62.

Operating and Storage Temperature

The recommended storage temperature for all Control Panels is ‐10°C to 60°C (14°F to 140°F).

For optimal Control Panel use, operation temperature is 0°C to 49°C (32°F to 120°F).

No altitude range limitations have been reported while transporting Control Panels.

NOTE:

Table of Contents

Do you have a question about the Go Control and is the answer not in the manual?