Control Panel Programming Questions - 2gig Technologies Go Control Install Manual

CONTROL PANEL PROGRAMMING QUESTIONS

Q-5 Enter exit delay, in seconds (45-
120)
DEFAULT: 60 seconds
(Required SIA CP-01 Default)
The Exit Delay can be set from 45 to 120 seconds.
• The default (60) sets the Exit Delay to 60
seconds.
• To change the Exit Delay, enter a value from
(45‐120) seconds.
This default can be changed without
NOTE:
affecting SIA CP‐01 compliance.
Q-6 Enter entry delay 1, in seconds
(30-240)
DEFAULT: 30 seconds (Required SIA CP-
01 Default)
The Entry Delay #1 can be set from30 to 240
seconds.
• The default (30) sets the Entry Delay #1 to 30
seconds.
• To change the Entry Delay #1, enter a value
from(30‐240) seconds.
Per SIA CP‐01, the combination of the
NOTE:
Abort Window Dialer Delay (Q‐35) and
the Entry Delay (Q‐6 or Q‐7) cannot
exceed one minute.
Q-7 Enter entry delay 2, in seconds
(30-240)
DEFAULT: 45 seconds (Required SIA CP-
01 Default)
The Entry Delay #2 can be set from30 to 240
seconds.
• The default (45) sets the Entry Delay #2 to 45
seconds.
• To change the Entry Delay #2, enter a value
from(30‐240) seconds.
Per SIA CP‐01, the combination of the
NOTE:
Abort Window Dialer Delay (Q‐35) and
the Entry Delay (Q‐6 or Q‐7) cannot
exceed one minute.
42
©2013 2GIG Technologies Inc. All Rights Reserved.
Q-8 Select dialer (0-1)
DEFAULT: Disabled (0)
The dialer (digital communicator) can be enabled
for a monitored system or disabled for a local alarm
or when the cell radio module is used exclusively
for reporting.
• The default (0) sets the dialer as disabled.
• To turn on the dialer, select enabled (1).
If the dialer is disabled with this
NOTE:
programming question, telephone line
failure detection is also disabled
regardless of the setting of the telephone
fail detection question Q‐63.
Q-9 Enter dialing prefix (0-4 digits)
DEFAULT: No default
Some telephone PBX systems require a dialing
prefix to acquire a dial tone.
• If the telephone system that the Control Panel
is connected to requires a dialing prefix, enter
up to four digits.
• The Shift button accesses the pound and star
symbols. The P button adds a 3‐second pause
to the dialing.
Q-10 Enter call waiting disable code
(0-6 digits)
DEFAULT: No default (Required SIA CP-
01 Default)
If the subscriber's telephone line has call waiting,
incoming call tones on the line could interfere with
a communicator report to the Central Station. To
prevent this, the communicator can send the call
waiting disable code before making a report.
• If call waiting is active on the telephone line,
enter the call waiting disable code.
• The Shift button accesses the pound and star
symbols. The P button adds a 3‐second pause
to the dialing.
If the first attempt fails, this code will
NOTE:
be ignored on the rest of the attempts.