Table of Contents
Advertisement
To set the calendar and the clock press Set
10
Date and Set Time.
On the Set Date screen, use the ↓ and ↑
arrows to set the month, day, and year. On the
Set Time screen, use the ↓ and ↑ arrows to
set the hours, minutes, and AM/PM. When
done, press Ok. A confirmation screen
appears. Verify the time and date, then press
Ok again.
If the cell radio module is installed and
11
registered, the date and time is set
automatically.
•
To return to the Security Screen, press Back
OR
•
To return to the Home Screen, press the
button.
INSTALLER TESTING
Testing the System
After the installation is complete and the Control
Panel programming is complete, the system must
be tested to ensure proper operation.
System testing is performed through the Installer
Toolbox screen.
1
Press the lower right corner of the Home
screen.
To access the Installer Toolbox, enter the
2
Installer Code (default = 1561).
Sounder Disable/Enable
Because testing causes the Control Panel's internal
and external alarm sounder to activate, an option
to lower the sounder is available.
1
From the Installer Toolbox Screen, press
Disable Sounder.
A confirmation screen appears. Press Ok. Four
2
beeps will sound from the internal sounder,
and a short siren will sound from the external
sounder. The external siren will be disabled
and the internal sounder will be lowered for
30 minutes.
A second confirmation screen appears to
3
verify that the test sounds occurred. Press Ok.
While the sounder is disabled, the Sounder
4
Disable Icon appears on the status bar.
The Sounder Disable automatically times out
5
after 30 minutes, and the sounder
automatically becomes active again.
To re‐enable the sounder manually, follow these
steps:
1
From the Installer Toolbox Screen, press
Enable Sounder.
A confirmation screen appears. Press Ok.
2
Zone Reporting Test
To verify that the Central Station correctly receives
reports from each zone (sensor type), do the
following tests:
Inform the Central Station that test signals will
1
be sent.
2
Trigger a 24‐hour fire sensor (if installed) or
press the Fire emergency button (if enabled),
wait about 45 seconds for the report to
complete, then disarm the Console.
©2013 2GIG Technologies Inc. All Rights Reserved.
Final Installation Setup
57
Advertisement
Table of Contents
Need help?
Do you have a question about the Go Control and is the answer not in the manual?
Questions and answers