Installer Programming - 2gig Technologies Go Control Install Manual

INSTALLER PROGRAMMING

ACCOUNT REGISTRATION
The account registration data was created from the
installation contract and is stored in a database at
the Central Station. The data includes items such as
the customer name, address, and the Central
Station telephone number and assigned Control
Panel account number.
The registration process is used to enroll the
Control Panel with the Central Station and involves
the following:
• Selecting the sensor number for a particular
device Selecting the RF sensor type
• Learning‐in the RF sensor's serial number
• Selecting the other options for the sensor as
shown in the following diagram
RF sensors are reported to the
IMPORTANT:
Control Panel as sensors #1‐48.
Q-1 Sub-Questions
The options that can be set for each RF sensor are:
• Sensor number — 01‐48
• Sensor Type — Exit/Entry, perimeter, interior...
• Sensor Equipment Type — Certain sensor types
will ask for equipment type
• Sensor Equipment Code — Sensor model
(door/window, PIR, smoke detector, etc.)
• Sensor Other Equipment Code — Enter special
equipment code (only shown for sensors set as
"other")
• Sensor Serial # — Serial number labeled on
sensor; manually enter or "learn" by sending
signal
• Sensor Equipment Age — New install or
existing sensor
• Sensor Loop Number — Built‐in contacts or
external contacts on DW11 Door/Window
sensor
• Sensor Dialer Delay — Delayed or instant
communicator reports for the sensor (delay
time is set by dialer abort window)
• Sensor Voice Descriptor — Name assigned to
the sensor and announced if programmed
• Sensor Reports — Communicator reports or no
communicator reports for the sensor
• Sensor Supervised — Control Panel checks for
status reports from the sensor, or does not
check for status reports
• Sensor Chime — Select voice announcement
and chime options for the sensor
28
©2013 2GIG Technologies Inc. All Rights Reserved.
1 Scroll between op ons using the ← and →
arrows. Move to the previous or next prompt
by pressing the ↑ and ↓ arrows.
To program another sensor click next.
2
To exit programming, click skip then end and
3
exit. Upon exit, the panel takes a several
seconds to reboot.