Restoring Programming Defaults - 2gig Technologies Go Control Install Manual

Go!Control Wireless Security System | Install Guide
Enter the Master User Code to proceed with
2
the test.
The Telephone Test screen appears. The top
3
portion of the screen shows the actions that
the Control Panel is taking. The bottom
portion of the screen shows the results of the
actions. Scroll through the status screen with
the ↓ and ↑ arrows.
When the test is complete, press Ok to return
4
to the Toolbox.
RESTORING PROGRAMMING
DEFAULTS
To soft reset the Control Panel back to the factory
defaults, use the Restore Default option in the
Installer toolbox.
The Control Panel may also be "hard"
NOTE:
reset to out‐of‐the‐box factory defaults by
pressing and holding the emergency and
home buttons while applying power (if
not disabled through programming
questions Q‐44 & Q‐45).
Restore Defaults
The Restore Defaults screen provides a method to
selectively reset the Control Panel to its default
programming values instead of using a full hard
reset. Two check box options are available (one or
both must be checked):
• If the Zones box is checked, all data for the 48
sensors will be erased and replaced with the
default values.
• If the Console box is checked, all the Control
Panel programming questions (except Z‐Wave
questions Q79‐Q83) will be erased and
replaced with the default values:
• The User Codes will be erased
• The backlight timeout will be reset to five
minutes
• Brightness/Volume settings will be reset
60 ©2013 2GIG Technologies Inc. All Rights Reserved.