Table of Contents
Advertisement
3.1
INSTALLING THE BATTERY
Insert the battery supplied with the device as follows:
1.
Using a screwdriver, unscrew the battery compartment cover (item 1)
from the back of the housing.
2.
Insert the 9V battery supplied (item 2), observing polarities.
3.
Close the battery compartment cover and screw it onto the housing.
3.2
TURNING THE CLAMP-ON METER ON
With the rotary switch set in the OFF position, turn the switch to the
•
desired function. The display lights (all symbols) for a few seconds (see
§1.3), then the screen of the function chosen is displayed.
The clamp-on meter is now ready to make measurements.
•
3.3
TURNING THE CLAMP-ON METER OFF
The clamp-on meter can be turned off in two ways:
Manually - Turn the switch to the OFF position.
•
Automatically - After ten minutes with no activity, the instrument will turn
•
OFF. Thirty (30) seconds before the device is switched off, an audible
signal sounds intermittently. To re-activate the device, press any button
or turn the rotary switch.
3 USE
1
Figure 6 : Battery Compartment
19
2
Advertisement
Table of Contents
