Configuring The Camera With The Camera Configuration Tool Plus (Cct+); Opening The Configuration Tool; Closing The Configuration Tool - Basler L100k User Manual

Configuring the Camera
4.1 Configuring the Camera with the Camera
Configuration Tool Plus (CCT+)
The Camera Configuration Tool Plus (CCT+) is a Windows
change the camera's settings. The tool communicates via the RS-644 serial connection in the
Camera Link interface between the frame grabber and the camera. The tool automatically
generates the binary programming commands that are described in Section 4.2. For instructions
on installing the tool, see the installation booklet that was shipped with the camera.
This manual assumes that you are familiar with Microsoft Windows and that you have a basic
knowledge of how to use programs. If not, please refer to your Microsoft Windows manual.

4.1.1 Opening the Configuration Tool

1. Make sure that the properties for the RS-644 serial port on your frame grabber are properly
configured and that the camera has power.
2. On the desktop of your computer, click Start, click Programs, click Basler Vision Technolo-
gies, click CCT+, and then click CCT+ to start the CCT+ (default installation).
During start-up, a start-up screen can be seen.
If start-up is successful, the tool will open. To familiarize yourself with using the tool, press the
F1 key and look through the online help included with the tool.
If start-up is not successful, the tool will automatically close. If this happens, refer to the CCT+
Installation Guide for possible causes.

4.1.2 Closing the Configuration Tool

Close the configuration tool by clicking on the
4-2
DRAFT
button in the upper right corner of the window.
™
based program used to easily
BASLER L100
k Series