Connector Types - Basler L100k User Manual

6-Pin Micro-miniature Receptacle
The pin assignments for the 6 pin, micro-miniature receptacle used to supply power to the camera
are shown in Table 2-2.
Pin
Number
1
1, 2
3
4
2
5, 6
1
Pins 1 and 2 are tied together inside of the camera.
2
Pins 5 and 6 are tied together inside of the camera.
Table 2-2: L100
Figure 2-2: L100

2.1.3 Connector Types

The 26 pin connector on the camera will be a female .050" MDR connector as called for in the
Camera Link Specification.
The 6 pin connector on the camera is a Hirose micro-miniature locking receptacle (part # HR10A-
7R-6PB) or the equivalent. The recommended mating connector is the Hirose micro-miniature
locking plug (Part # HR10A-7P-6S). This plug will be shipped with each camera. It should be used
to terminate the cable on the power supply for the camera.
BASLER L100
k Series
DRAFT
Signal
Direction
Name
12 V In Input
Input
DC Gnd
Pin Assignments for the 6-pin Micro-miniature Receptacle
k
Pin Numbering
k
Level Function
+12 VDC Camera Power Input
Not Connected
Not Connected
Ground DC Ground
Camera Interface
2-3