Configuring The Camera With The Camera Configuration Tool Plus (Cct+); Opening The Configuration Tool; Closing The Configuration Tool; Configuration Tool Basics - Basler A400K User Manual

Configuring the Camera
4.1 Configuring the Camera with the
Camera Configuration Tool Plus (CCT+)
The Camera Configuration Tool Plus (CCT+) is a Windows
change the camera's parameter settings. The tool communicates via the RS-644 serial connection
in the Camera Link interface between the frame grabber and the camera. The tool automatically
generates the binary programming commands that are described in Section 4.3. For instructions
on installing the tool, see the installation booklet that was shipped with the camera.
This manual assumes that you are familiar with Microsoft Windows and that you have a basic
knowledge of how to use programs. If not, please refer to your Microsoft Windows manual.

4.1.1 Opening the Configuration Tool

1. Make sure that the properties for the RS-644 serial port on your frame grabber are properly
configured and that the camera has power.
2. To start the CCT+, click Start , click All Programs , click Basler Vision Technologies , and click
CCT+ (default installation).
During start-up, a start-up screen can be seen.
If start-up is successful, the tool will open. To familiarize yourself with using the tool, press the
F1 key and look through the online help included with the tool.
If an error occurs, the tool is automatically closed after start-up. Refer to the CCT+ Installation
Guide for possible causes.

4.1.2 Closing the Configuration Tool

Close the CCT+ by clicking on the

4.1.3 Configuration Tool Basics

The volatile (RAM) memory in the camera contains the set of parameters that controls the current
operation of the camera. This set of parameters is known as the work configuration set or "work
set" (see Section 3.14). The CCT+ is used to view the present settings for the parameters in the
work set or to change the settings.
When the CCT+ is opened and a port is selected, it queries the camera and displays a list of the
current settings for the parameters in the work set.
4-2
DRAFT
button in the upper right corner of the window.
™
based program used to easily
Basler A400k