Configuration Tool Help - Basler L100k User Manual

Configuring the Camera
Keep in mind that the Work Set is stored in a volatile memory. Any changes you make
to the Work Set using the configuration tool will be lost when the camera is switched
off. To save changes you make to the Work Set, open the Camera menu of the config-
uration tool and save the modified Work Set into one of the camera's 15 User Sets. The
User Sets are stored in non-volatile memory and will not be lost when the camera is
switched off (see Section 3.10).
Alternatively, you can also save the Work Set to the hard disk of your computer and
load it from hard disk.
If you want your changes to be loaded into the Work Set at the next power on, go to
the Camera menu and set the Startup Pointer to the User Set where you saved your
changes.

4.1.4 Configuration Tool Help

The configuration tool includes a complete on-line help file which explains how to change a
setting, to copy the Work Set to a User Set, to Copy a User Set or the Factory Set to the Work Set,
or to set the Startup Pointer. To access on-line help, press the F1 key whenever the configuration
tool is active.
4-4
DRAFT
BASLER L100
k Series