Read Reference Gain Values - Basler L100k User Manual

Configuring the Camera

4.2.7.6 Read Reference Gain Values

Purpose: To read the reference gain values that are determined during the camera's factory
calibration procedure (see Section 3.5.1 on how to use the reference gain values).
Type: This is a read only command.
Read Command:
Response:
Data Format:
4-26
DRAFT
Cmd-ID R/W-Flag
0x08 1
Cmd-ID R/W-Flag
0x08 0
Each reference gain is stored as a 16 Bits followed by a decimal point
followed by 16 more Bits:
Reference Gain = High Byte b.d.p.
b.d.p.: before decimal point
a.d.p.: after decimal point
For example:
Odd pixel reference gain = Byte 4
Byte Even/odd
reference gain
Byte 1 odd
Byte 2 odd
Byte 3 odd
Byte 4 odd
Byte 5 even
Byte 6 even
Byte 7 even
Byte 8 even
Bytes 9 to 16 must be ignored. These bytes are not used on the L100k.
Data Length
16
Data Length
16
High Byte a.d.p.
×
256 + Low Byte b.d.p. + ----------------------------------------- -
Byte 2 Byte 1
×
256 + Byte 3 + ---------------- - + ---------------- -
256 65536
Position before/
after decimal point
after
after
before
before
after
after
before
before
Data
-
Data
16 Bytes
Low Byte a.d.p.
+ ---------------------------------------- -
256 65536
High/Low
byte
low byte
high byte
low byte
high byte
low byte
high byte
low byte
high byte
BASLER L100
k Series