Basler L100k User Manual page 62

Operation and Features
In normal operation, the camera is set to use all of the pixels in the array. To use all
of the pixels, the starting pixel should be set to 1 and the length in pixels to 1024 for
cameras with a 1024 pixel sensor or 2048 for cameras with a 2048 pixel sensor.
You can set the area of interest using either the Camera Configuration Tool Plus (see Section 4.1)
or binary commands (see Section 4.2).
With the Camera Configuration Tool Plus, you use the AOI Starting Pixel and the AOI Length
settings in the AOI parameter group to set the area of interest.
With binary commands you use the Area of Interest Starting Pixel and Area of Interest Length in
Pixel commands.
3-30
DRAFT
BASLER L100
k Series