Test Image Command; Camera Reset Command - Basler L100k User Manual

4.2.5 Test Image Command

Purpose: To enable or disable a test image. See Section 3.9 for an explanation of the available test
images.
Type: This is a read or write command.
Read Command:
Response:
Write Command:
Response:
Data Format:

4.2.6 Camera Reset Command

Purpose: Initiates a camera reset. The behavior is similar to a power up reset.
Type: This is a write only command.
Write Command:
Response:
Data Format:
BASLER L100
k Series
DRAFT
Cmd-ID R/W-Flag
0xA1 1
Cmd-ID R/W-Flag
0xA1 0
Cmd-ID R/W-Flag
0xA1 0
None
Byte 1 An ID that specifies the test image
(see the table below).
ID Test Image
0x00 No test image
0x01 Test Image 1 (gray gradient)
0x02 Test Image 2 (moving gray gradient)
Cmd-ID R/W-Flag
0x42 0
None
Byte 1 Low byte
Byte 2 High byte
Configuring the Camera
Data Length Data
1
Data Length Data
1 1 Byte
Data Length Data
1 1 Byte
Data Length Data
2 2 Bytes
0xCF is always used
0x07 is always used
-
4-23