Performance Specifications - Basler L100k User Manual

Introduction

1.2 Performance Specifications

Specifications
Sensor
Pixel Size
Fill Factor
Spectral Response
Anti-blooming
Fixed Pattern Noise
Photo Resp. Non-uniformity
Pixel Clock Speed
Single Output Modes:
Dual Output Modes:
Maximum Line Rate
1024 Pixel Cameras:
2048 Pixel Cameras:
Minimum Line Rate
Pixel Depth
Video Output Type
Video Output Formats
Synchronization
Exposure Time Control
Gain and Offset
Connectors
Power Requirements
Lens Adapters
Housing Size (L x W x H)
Weight
Conformity
Table 1-2: L100
1-2
DRAFT
Series Performance Specifications
k
L101
k
1024 pixel or 2048 pixel linear CCD Thomson TA7813
10 µm x 10 µm (10 µm pitch)
100 %
300 - 1000 nm, peak at 700 nm (See Figure 1-1)
1:100 or better
± 1 gray value
± 5 % typical
20 MHz
20 MHz
18.7 kHz
9.5 kHz
Programmable 8 bit or 10 bit
Camera Link LVDS (RS-644 LVDS when used with the op-
tional Basler Interface Converter (k-BIC))
Single 8 Bit, Single 10 Bit, Dual 8 Bit, or Dual 10 Bit
Via external ExSync signal or free-run
Edge-controlled, level-controlled, or programmable
Programmable via a serial link
One, 26 pin, female MDR connector
One, 6 pin, Hirose micro-miniature push-pull receptacle
12 VDC ± 10% 12 VDC ± 10%
max. 6.5 W max. 8.5 W
1024 Pixel Cameras: C-mount or F-mount
2048 Pixel Cameras: F-mount
without lens adapter: 37.6 mm x 62 mm x 62 mm
with C-Mount Adapter: 40.1 mm x 62 mm x 62 mm
with F-mount adapter: 69.1 mm x 62 mm x 62 mm
without lens adapter: ~ 175 g
with C-mount adapter: ~ 220 g
with F-mount adapter: ~ 285 g
CE, FCC
L103 L104
k
40 MHz 62.5 MHz
20 MHz 31.25 MHz
35.7 kHz 58.5 kHz
18.7 kHz 29.2 kHz
1 kHz
12 VDC ± 10%
max. 10 W
BASLER L100
k
k Series